Grass Valley Kaleido-MX (1RU) v.7.80 - Manual (Page 18)

4
Installation
Frame Interface
Frame Interface
Front of the Kaleido-MX (1RU) frame
Opening the frame door reveals that the unit is visually divided into three sections:
The table below indicates how the cards included in your Kaleido-MX (1RU) are distributed
in the housing frame:
Left The controller card with its attached control panel is seen
on the left. The card itself is installed in a horizontal slot
near the top. A power supply is located below the
controller card in the frame.
Center Four card slots are laid out horizontally, two across by two down. One or two output
cards occupy slots 3 and 4, on the right, and an input card occupies slots 1 and 2, on
the left. (The input card itself is inserted in slot 2, at the bottom.) All dual-head models
have their output card in the top slot on the right (slot 3). In the case of the dual-head
model with 24 inputs, an additional input card occupies the bottom slot on the right
(slot 4). For example, the center area of a system with one input card and one output
card appears as follows:
Right A second power supply is located on the lower right,
and above it is a single slot (slot 5) reserved for system
cards.
Note: This slot supports ONLY designated system
cards; do not insert any other cards. At the time of
writing, only the GPI-1501 card is supported.
Slot Card Card model Applies to...
2 Input A KMX-3901-IN-16- Q 16 × 4
KMX-3901-IN-16- D 16 × 2, 16 × 1
KMX-3901-IN-8-D 8 × 2, 8 × 1
Input B KMX-3901-IN-16- D 24 × 2, 24 × 1
3 Output A KMX-3901-OUT-D 24 × 2, 16 × 4, 16 × 2, 8 × 2
KMX-3901-OUT-S 24 × 1, 16 × 1, 8 × 1
Slot 1 (empty)
Slot 4 (empty)
Output card in slot 3
Input card in slot 2