Grass Valley Kaleido-MX (1RU) v.7.80 - Manual (Page 21)

7
Kaleido-MX (1RU)
Hardware Description & Installation Manual
Kaleido-MX 24 × 1, and 24 × 2
Kaleido-MX systems with 24 inputs are available in single-head and dual-head models.
They share the same rear-panel layout, including 24 input connectors, 2 HDMI outputs (one
of which is not enabled, in the case of the single head model), 2 HD-SDI monitoring
outputs, 2 analog audio outputs, 1 SDTI audio input, 1 LTC input, 1 reference input,
1 Ethernet connector, 1 RS-422 connector, 20 GPI inputs, and 8 configurable GPI
input/output.
Kaleido-MX-24x2 rear panel
Mechanical Installation
Unpacking
Make sure the following items have been shipped with your Kaleido-MX. If any of these are
missing, contact your distributor or Grass Valley (see
Contact Us , on page 41).
• Kaleido-MX (1RU) unit with pre-installed cards (1–3 input cards, 1 or 2 output cards, a
Densité CPU-ETH2 controller card, and a GPI-1501 GPI I/O module), and 1 or 2 power
supplies (second power supply optional)
• Two AC power cords
• Two cable retainers
• Two WECO mating connectors for each output card (for the analog audio monitoring
outputs), plus one for the CPU-ETH2 controller card’s GPI output:
Note: Due to space constraints at the 1RU rear panel, the 16 × 4 model does
not support analog audio outputs. Audio monitoring is available at the SDI
and HDMI outputs only.
1RU model WECO connectors
8 × 1 3
8 × 2 3
16 × 1 3
16 × 2 3
16 × 4 1
24 × 1 3
24 × 2 3
Note: Due to space constraints at the 1RU rear panel, the 16 × 4 model does
not support analog audio outputs. Audio monitoring is available at the SDI
and HDMI outputs only.