Grass Valley Kaleido-MX (1RU) v.7.80 - Manual (Page 46)

32
Operation
Network Settings Panel
Network Settings Panel
Kaleido-MX output cards are shipped with default network settings, which you must
replace with values suitable for your network environment. You may need to consult your
network administrator to get the correct values. Enter the appropriate IP address, mask and
gateway information to configure a Kaleido-MX output card within your Ethernet network.
Click Apply to set these values into the card, or Cancel to leave the original values
unchanged.
Info Panel
When a Kaleido-MX input or output card is included in an iControl environment, certain
information about the card may be made available to the iControl system. In the boxes with
a white background, you can type labels and comments that will make this card easier to
identify in a complex setup.
Notes
• These settings apply to the rear-panel Ethernet port of the Kaleido-MX
output cards; not to the Ethernet ports at the back of the Densité controller
card.
• On all Kaleido multiviewers, the network adapters are set to auto-
negotiate. By default, the connection speed and duplex mode will be set
automatically based on the corresponding port settings on the switch.
• The position of the output card is not configurable; the information is
presented here for information only.
• Quad-head Kaleido-MX systems, which include two output cards, require
three IP addresses: one for each output card, and a virtual IP address for the
system. A dual- or single-head system requires only one IP address (the
output card’s IP address automatically doubles as the system IP address).
Refer to the Kaleido-MX (1RU) Quick Start Guide for detailed setup
information.