Grass Valley Kaleido-MX (1RU) v.7.80 - Manual (Page 42)

28
Operation
Remote Control Using iControl
* All output cards within a Kaleido-MX frame must have their output heads configured with the same refresh
rate. If your frame is referenced, then the heads’ refresh rate must also match the reference signal's refresh
rate.
** Parameters shown here in braces { } will display the actual value of the item and not the text shown above.
** Parameters shown here in braces { } will display the actual value of the item and not the text shown above.
*** The Kaleido-MX does not support converting an input module into a 4K UHD prescaler. The SFP ports
are not yet supported.
Remote Control Using iControl
The Kaleido-MX may be controlled by using Grass Valley’s iControl version 4.43 or later. This
section describes the two control panels associated with the Kaleido-MX’s input and output
cards and their use. Refer to the iControl User’s Guide for information about setting up and
operating iControl.
In iControl Navigator, iControl Web, or iControl Solo, double-click the icon for a Kaleido-MX
input or output card (KMX-3901-OUT, KMX-3901-IN-8-D, KMX-3901-IN-16-D, or KMX-3901-
IN-16-Q) to open the associated control panel.
100Mbps full-duplex
OUTPUT A IP EDIT ###.###.###.###
OUTPUT B IP EDIT ###.###.###.###
{POSITION}**
{MAC ADDRESS}**
Kaleido-MX input card local menu
STATUS CARD STATUS {CARD STATUS}**
INPUT STATUS 1 {FORMAT}**
2 {FORMAT}**
3 {FORMAT}**
16 {FORMAT}**
CONFIG*** 4K UHD PRESCALER ENABLE
DISABLE
SFP CONFIG SFP OUT 1 ON
OFF
SFP OUT 2 ON
OFF
SFP OUT 3 ON
OFF
SFP OUT 4 ON
OFF
{CARD VERSION}**
Kaleido-MX output card local menu (continued)
...