Grass Valley M-2100 - Manual (Page 17)

MMCP Installation/Operation Manual 1-9
Control Panel Cabling
Use the following procedure to set the IP address using the Netburner PC
tool.
1. Connect a PC and one MMCP to the same 10 BaseT Ethernet network.
Note Only one panel at a time should be connected to the PC to allow positive iden-
tification of the panel to be programmed.
2. Open the Netburner IPSetup.exe application and locate the panel on
the network as shown in
Figure 1-10 . The application will find
Netburner devices on the network and identify them by their MAC
addresses.
3. Type in the desired IP address in the IP boxes.
4. Set the Subnet Mask in the Network Mask boxes to 255.255.255.0.
5. Set the GateWay IP address to 0.0.0.0.
6. Set the DNS IP address to 0.0.0.0.
7. When finished, click on the Close button.
8. The panel must be rebooted for the new IP address to take effect.
Remove power momentarily to reboot.
Figure 1-10. Netburner IPSetup PC Tool