Grass Valley M-2100 - Manual (Page 18)

1-10 MMCP Installation/Operation Manual
Section 1 — Installation
Direct PC Connection
You may use a PC equipped with an Ethernet interface and a web browser
to change the panel IP address as follows.
1. Connect the PC’s Ethernet port directly to the MMCP panel ENET RJ45
connector J2 (
Figure 1-9 on page 1-6 ).
Note A crossover Ethernet cable (Tx/Rx pair crossed) is needed when connecting
a PC directly to the panel without a hub intermediary.
2. Run the web browser and type in the default IP address of the MMCP
panel as http://192.168.0.250. The PC IP address must have a network
value (first three octets) that matches the default IP address.
If the address is found, a Panel Information screen similar to Figure 1-11
will appear.
3. Click on the BOOT link to go to the Boot Configuration screen.
Figure 1-11. Panel Information Screen