Grass Valley M-2100 - Manual (Page 38)

2-14 MMCP Installation/Operation Manual
Section 2 — System Operations
If the hot cut is performed on a crosspoint configured with a preroll
enabled, the hot cut initiates the preroll sequence.
If the crosspoint is configured with a machine start or relay enabled, the hot
cut triggers the configured device.
The following hot cut actions will apply to transitions on the M–2100:
■ Hot cuts from the Program bus will take precedence over any transition
in progress, either from the MMCP or automation.
■ Hot cuts from automation will not be accepted if any transition (from
the MMCP or automation) is in progress.
■ Hot cuts from the Preset bus will take precedence if the Enable Transition
Interrupt check box has been selected in the MMCP form in Configura-
tion Manager.
■ Hot cuts will remove any selected keys or SqueezeBack selections if
they are on-air.
Hot Cut Transition Interrupts
A transition interrupt situation occurs when a new Program source is
selected during a transition in progress. The following functions take place:
■ Any Preroll/Transition is canceled.
■ Any Program bus Audio Overs are cancelled.
Selection of a Program audio source will recall the audio level and trim set-
tings in effect when that source was last selected on the Program bus.
Custom Transitions
You can customize audio/video transitions by assigning them different
parameters in Configuration Manager. Custom separate transition types,
transition durations, and other associated parameters can be configured. A
combination of custom transitions and standard transitions is available.
Note This feature, called the 2100-SAV (Split Audio Video) is a software enabled
option and must be purchased.
Refer to the Installation and Service Manual for complete configuration
instructions. Custom transitions are configured in the
MCP form, in the
Custom Transitions menu.