Grass Valley M-2100 User Manual

Page 19

Advertising
background image

MMCP Installation/Operation Manual

1-11

Control Panel Cabling

4.

In the Boot Configuration screen (

Figure 1-12 on page 1-11

), enter the

Ethernet IP

address for this panel to put it on the MCP Net with the

frames it will be controlling.

5.

The

Subnet Mask

should be 255.255.255.0 (the subnet mask for the

M–2100 network).

6.

The

Gateway IP

should be set to 0.0.0.0.

7.

Select

Store Changes to Non-Volatile Memory

to store these values or

Cancel

to

make no changes.

Note

The MAC address of the Ethernet card inside the panel is also given in read-
only format.

8.

Disconnect the panel from the PC and install it onto the MCP Net
Ethernet network.

9.

Repeat this procedure on all the MMCP panels to be used with your
M–2100 system, entering unique MCP Net IP addresses (last octet
different) for each MMCP panel.

Figure 1-12. Boot Configuration Screen

Advertising
Popular Brands
Popular manuals