Grass Valley M-2100 - Manual (Page 31)

MMCP Installation/Operation Manual 2-7
Using Multichannel Control
Automation Enable
The Channel Control buttons are also used to enable/disable automation
control for the corresponding channel.
Automation Control can be enabled/disabled for all eight channels inde-
pendently of the
Channel Control buttons status. That is, a channel does not
have to be chosen as a primary or secondary in order to enable/disable
automation.
To enable/disable automation on a channel, do the following:
1. Press and hold the Mode/Function button.
2. Press and release the Channel Control button corresponding to the
automation control you wish to enable or disable.
3. The corresponding yellow LED above the Channel Control button
( Figure 2-2 on page 2-3 ) will light when automation control of the
channel is enabled and go off when control is disabled.