Software installation, System configuration – Grass Valley M-2100 User Manual
Page 24
Advertising
1-16
MMCP Installation/Operation Manual
Section 1 — Installation
Software Installation
The MMCP requires that the M–2100 is running v5.0 or later software.
When new system software is released, installation is done with the Net-
burner AutoUpdate PC Tool shown in
. Instructions for using
the tool are given in the Release Notes that accompany the upgrade. The
Release Notes will also cover new operating and configuration informa-
tion.
Figure 1-15. Netburner AutoUpdate PC Tool
System Configuration
After installing new software, you will need to configure the system with
Configuration Manager. The
MCP
form in this application is used to set the
panel parameters. Refer to your M–2100 Installation and Service Manual
for complete instructions.
Advertising