EverFocus EDR-1610A - Manual (Page 11)

EDR910_1610_ma_en_rev1 00 - 11 -
1.6 SCREEN DISPLAYS
Here’s an overview of the screen displays appearing on the MAIN monitor:
(1) Channel display: shows the selected video channel’s description
(2) Event: Event display, may be channel-related or global
Channel-related types of event:
Alarm: Display of an alarm triggered by alarm input contact
Motion: Motion detection of the respective camera
Video
loss: Video signal loss of the respective camera
Sequence: Sequential operation of the respective video channel
* - In multiscreen display, this icon indicates the channel selected for sequential
display. Selection via SELECT key. Upon sequence activation, the “*” icon is
replaced by
Global types of event:
OT - Over Temperature HDD: Alarm message upon HDD over
temperature, displayed in red on all video channels. The device should
immediately be switched off. In case the „FAN“ (fan damage) message
occured previously, contact the technical service for trouble shooting. If the
fan works properly, check the device‘s position as regard to ambient
temperature (max. 40°C, fan must not be covered, ensure the sufficient
ventilation if device is installed in cabinet or rack).
1. Channel display
2. Event (here: video loss)
3. Display selection
4. Playback status
5. Recording status
S
OT
M
A
V
S