EverFocus EDR-1610A - Manual (Page 20)

EDR910_1610_ma_en_rev1 00 - 20 -
2.6 PS/2 mouse installation
EDR910/1610 may optionally be controlled through USB wheelmouse which must be
connected before system start-up. The mouse connector is the lower USB socket at the
front panel.
2.7 Network connection
EDR910/1610 DVRs provide fast MPEG-4 format image transmission and network remote
configuration.
This chapter doesn‘t go into basic network technique details. For further information,
especially about router installation and internet connection, please refer to the
publication "EverFocus network technique".
Physically, two basic types of connection are possible:
2.7.1. Direct PC connection through crossover network cable
The point-to-point connection of DVR and PC requires a crossover (crossed) network
cable. This type of connection does not allow the connection of several PCs or DVRs.
Make sure that the PC is equipped with a 100 MBit compatible network connection.
2.7.2. Network connection through patch cable
The connection to an existing network requires a normal patch cable (wired 1:1). The
illustration shows the connection to a network switch.