EverFocus EDR-1610A - Manual (Page 32)

EDR910_1610_ma_en_rev1 00 - 32 -
(4) DURATION:
Alarm duration for N.O. and N.C. contact types. Duration applies to recording, screen
change, buzzer and output contact and is adjustable from 1~99 seconds.
(5) ALARM OUTPUT:
Output relay activation. 1: Output relay 1 is switched
in case of alarm
NONE: Output relay is deactivated.
(6) ALARM EMAIL:
By selecting “ON”, an email is sent in case of alarm, containing the alarm message, the
camera’s alarm image and the DVR IP address as sender.
Define the email recipiant’s details in the NETWORK menu.
(7) BUZZER:
Alarm buzzer activation ENABLE: Alarm buzzer is activated.
DISABLE: Alarm buzzer is deactivated.
(8) ALARM NETWORK:
Network alarm function activation. Network alarm reception requires installation of the
optionally available PowerCon software. The network alarm transmits both the alarm
message and the DVR IP address as sender to up to 3 recipiants.
YES: Network alarm is activated.
NO: Network alarm is deactivated.
(10) MAIN MON: Alarm reaction on MAIN monitor in case of alarm.
NO CHANGE: The currently selected main monitor
display does not change.
FULL SCREEN: Monitor displays the alarm camera (see
(3)) image in full screen.
(11) CALL MON: Alarm reaction on CALL monitor in case of alarm.
NO CHANGE: The currently selected call monitor display
does not change.
Camera 1~9 (16): Monitor displays full screen image of the
camera defined within the menu item.
(12) SUMMARY
The SUMMARY menu item gives a summary on the settings for control purpose.
Use the JOG to browse the individual settings.
ATTENTION: This menu does not allow any editing of settings.