LinPlug CrX4 - Manual (Page 13)

The Generator Controls
The upper and lower part in this section are apart from the just mentioned
two controls absolutely identical. The respective controls in each Generator
are partly the same and partly depending on the type of Generator used:
Common Controls on Top
Each Generator also has its own On/Off switch located to the left of the
module's menu. If you don’t want to use one of the Generators it's best to
switch it off as this conserves CPU resources.
Next is a Menu which allows to select the generator type. There are 5
different available within the CrX4: Time Sampler, Wavetable Sampler,
Loop Sampler, Oscillator and Noise Oscillator.
Finally there is a Edit Helper Menu which offer functions to copy and paste
one generators settings to a different generator and to init the settings of a
generator.
Common controls on the Left
Each Generator module contains
controls for Semitone, and Cent.
Semitone sets the Generator pitch in
semitones. A wide range covering
multiple octaves up or down is
available: -60 to +60 semitones (thats
-5 to +5 octaves).
Cent sets the oscillator pitch in cents (a
semitone is equal to 100 cents). A
range of -100 to +100 cents is
available.
The Track button determines whether
the Generator tracks the pitch of
incoming note messages. If Track is switched off the frequency of the
Generator depends on the Semitone and Cent settings only and is the
same whatever note is played.
Common controls on the Right
CrX4 User Manual 13