LinPlug CrX4 - Manual (Page 9)

output of filter 1 is send to filter 2 and the output of filter 2 is sent to the
effect 1.
Following the Filter section is the CrX4's Effects section which contains 6
independent effects processors. A wide range effects processors are
available including a three types of delay, a chorus, a phaser, a filter, a
reverb, a flanger, a gate, a stereo enhancer, a parametric EQ and a bit-
reduction/sample-rate reduction distortion.
Effect 1 is following Filter 1 and Effect 2 is following Filter 2, when the filters
are used in parallel, the output is mixed together and then goes through
Effects 3, 4, 5 and 6 which are in series. When the filters are used in serial,
all effects are processed in serial too.
The Modulation section contains the instrument’s Envelopes, LFOs,
Arpeggiator and Modulation Matrix. At various points throughout the CrX4’s
signal path you can modulate the processing parameters using the various
controls found in the instrument’s Modulation section.
The available modulation include 6 envelopes, 4 LFOs, a Modulation Matrix
“patchbay” and the arpeggiator. Independent from this every MIDI
Controllers can also be used to modulate any of the CrX4’s parameters and
some can control the Modulation Matrix (in example the Modulation
Wheel).
CrX4 User Manual 9