LinPlug CrX4 - Manual (Page 29)

Velocity to Main Volume
The Velo (Velocity) dial is used to control the degree to which the played
notes Velocity influences the patch volume. If turned folly clockwise, the
volume of the sound do largely depend on Velocity. When turned fully anti-
clockwise the Velocity does not affect the Volume of the preset.
Precision
The Precision control can be used to set the accuracy of the CrX4's signal
generation. When the Precision control is set to less than 100% small
inaccuracies are introduced at many different points in the CrX4's signal
chain. This is useful if you're aiming to replicate the warmth of an old
analog synthesizer.
Voice Limit
The Voices control is used to set the number of voices (polyphony)
available. The maximum polyphony is 32. A variety of settings are available
for polyphony. These include Mono, 2 to 12 and All.
One thing that may be confusing is the Mono setting. It can be explained as
follows. Say that you hold down one key and then press and release a
second key. In the case of the Mono voice setting, the first note will sound,
and then the second note sounds. When the second note is released the
first note sounds again. This creates a pedal tone effect typical for
monophonic synthesizers.
CrX4 User Manual 29