LinPlug CrX4 - Manual (Page 66)

Appendix C: Modulation Matrix Destinations
“---“
No modulation destination is selected.
Note: All 4 Generators offer the same modulation destinations in the Matrix,
so we only describe them once:
Gen Amplitude The amplitude of the Generator, used for in example
tremolo or to fade in or out a part of the sound
independently from the main volume.
Gen Pitch The pitch of the Generator, used in example for vibrato or
variable detuned voices or special effects.
Gen AuxMod 1
The destination of AuxMod depends on the type of
Generator that is currently loaded into the respective
Generator’s slot. The available destinations are marged
on the user interface with number 1 next to the parameter
and are as follows:
Loop-Sampler: Loop-Start
Wavetable Sampler: Speed
Time-Sampler: Time
Noise: Cutoff (both LP and HP)
Generator: Symmetry (Pulsewidth)
Gen AuxMod 2 The destination of AuxMod depends on the type of
Generator that is currently loaded into the respective
Generator’s slot. The available destinations are marked
on the user interface with number 2 next to the parameter
and are as follows:
Loop-Sampler:
Loop-End
Wavetable Sampler: <not used>
Time-Sampler: <not used>
Noise: Mix (only in Band-Reject)
Generator: Waveform
Gen Balance Balance of the Signal being sent to Filter 1 and Filter 2.
SampleStart This destination is only applied when a Loop-Sampler is
loaded, it then modulates the startpoint of the sampe
playback.
CrX4 User Manual 66