Logitek Electronic Systems Mosaic - Manual (Page 12)

Logitek Mosaic Reference Manual
Page 12
3 Physical Installation
The Mosaic surface is designed to be mounted on a desk in a semi-permanent studio installation.
The Meter Bridge, if optioned, can be screwed to the back of the Mosaic.
Power Supply Unit
The Power Supply Unit is an external supply. It is one rack unit high and contains dual power
supplies with dual inlets.
There are two IEC connectors on the rear of the Power Supply Unit. A power cable is supplied only
for US installations. International customers may contact their reseller for the supply of power cables
if required.
As the power supplies are of switch-mode type, there is no voltage selection required.
There are also two DB-25 connectors on the back of the power supply. One is for GPI inputs and
the other is for GPI outputs.
Mosaic Frames
A number of Mosaic frame sizes are available, depending on the total number of faders. A fader
module is 4 slots wide. The monitor module and wide softkey module are 2 slots wide. The narrow
softkey module is one slot wide. Single slot blank panels are used to fill any gaps if required.
The frame will be shipped with the modules connected and fitted as ordered. These modules are
not intended to be moved, however Fader modules are interchangeable. The internal COM port
connections determine the device addressing for each modules.
The Mosaic frame is 20 inches (508 mm) deep and 3 inches (76.2 mm) high without meter bridge.
With a meter bridge, the frame is 7 ¼ inches (184.15 mm) high. Frame widths are as follows:
M2 M2 M2 M2----F10 F10 F10 F10 10 10 10 10 Slot Frame Slot Frame Slot Frame Slot Frame
14.75 inches (374.65 mm) wide