Emerson IFT9701 - Manual (Page 82)

74 Model IFT9701 Transmitter Instruction Manual
Installing the Optional Display continued
8. Put the retaining clip, washer, and screw in place on the back of the display. See illustration,
below.
9. Put the display in place on the field wiring compartment. Tighten the screws evenly until the
display assembly is flush against the flowmeter housing and is completely sealed.
CAUTION
Failure to seal flowmeter housing could cause a short
circuit, which would result in measurement error or
flowmeter failure.
To avoid risk of condensation or excessive moisture
entering the flowmeter housing, ensure integrity of
gaskets, and fully tighten all housing covers.
Back of
display
Retaining clip