RISCO Group 5IN2047 Agility3 Full User Manual UK.pdf - Manual (Page 11)

Agility 3 User Manual
Page 11
Chapter 2 - Local System Operation
2.1 Setting your system
Setting your system causes the intrusion detectors to trigger an alarm when violated. The
setting operation will be followed by a local message announcement (if defined).
Before setting the system check the Ready LED and make sure that the system is ready
to be set. If the system is NOT ready to be set, secure or omit the violated zone(s), and then
proceed.
Failing to set the system will be indicated by the system
Your Agility offers the following kinds of setting:
Note: If you are unable to set the system, press the status key to view system messages.
Full setting:
Full setting prepares all of the system's intrusion detectors to activate an alarm if
violated, and is used when leaving the premises. The system will set after the
designated countdown time (Exit delay) and a local message will sound. Once you have
set the system, exit via the designated final exit door.
To set using Full setting procedure
Quick mode:
High security mode: Press + code
Quick mode:
High security mode: + code or proximity tag
Press
Send SMS : [Code][S], example, 1234S