RISCO Group 5IN2047 Agility3 Full User Manual UK.pdf - Manual (Page 50)

Agility 3 User Manual
Page 50
When you use a controlled user code for setting and unsetting, the system notifies the
monitoring service. You can assign these codes to your children or employees whose
comings and goings are of interest to you.
Codes 20-25: Non-controlled Codes
Non-controlled codes do not cause the system to send Set/Unset reports to the monitoring
service. The system sends an Unset report only if you use this code to unset the system
after an alarm occurrence.
Codes 26-27: Limited Codes
A Limited code is a code that is valid for one day only. This code automatically expires 24
hours after it has been programmed. You can assign a limited code to a visiting guest, for
example.
Code 28: Duress Code
The Duress code is designed for situations where you are being forced to operate the
system. This user code performs the operation selected, while sending a Duress event
message to your monitoring service.
Adding a New User
 To add a new user:
1. Click ADD NEW USER at the bottom of the table; the Add New User page
opens.
2. Enter the user's name in the field provided (16 characters max.).
3. Choose the user type from the available options.
4. Enter the new user's 4-digit passcode.
5. Enter the new user's passcode again for confirmation.
6. Enter your Master code.
7. Click Update.
Editing Existing Users
 To edit an existing user:
1. Click Edit for the user you want to modify; the Edit User page opens.
2. Edit the user's name in the field provided (16 characters max.). When editing an
existing user, you cannot change the user type.
3. Enter the user's 4-digit passcode.
4. Enter the user's passcode again for confirmation.
5. Enter your Master code.
6. Click Update.