Chapter 3 - remote system operation, 1 remote phone operation, Remotely accessing the system – RISCO Group 5IN2047 Agility3 Full User Manual UK.pdf User Manual
Page 19: Voice operations menu, Agility 3 user manual
Agility 3 User Manual
Page 19
Chapter 3 - Remote System Operation
3.1 Remote Phone Operation
The Agility enables you to operate the system from a remote touch-tone phone by
initiating a telephone call to or from the system and interacting with voice menus that
guide you through your required remote operation.
Remotely Accessing the System
Remotely accessing the system involves initiating a call to the system, and entering your
remote access code and the user code you usually enter in the system keypad.
To remotely access the system:
1.
From a remote touch-tone telephone, dial the number of the premises where
Agility is installed.
2.
If your system is connected to a land telephone line and an answering machine
is in use at the premises let the line ring once, then hang up, wait 20 seconds and
call again.
3.
If an answering machine is not in use at the premises wait until the system
picks up. After the system picks up a short tone is heard.
Note: When the system picks up, all phones on the same line are effectively
disconnected and cannot be used (depending on engineer wiring).
4.
Enter your 2 digit remote access code within 5 seconds (Default code = 00). The
following message is announced: "Hello, Please Enter Your User Code, Followed
By [#]".
Enter your user code followed by [#]. (Default code=1234)
5.
After your code is accepted a system status message is announced, followed by
the Operations menu. You can now perform the required remote operations.
Voice Operations Menu
The Voice Operations menu announces options and instructions on how to use the system
functions. The options in the Operations menu vary according to system status and your
access rights.
Following is a list of the remote operations options:
Operation
Quick Key Combination
Setting all partitions
Press [1][1]
Setting a selected partition
Press [1][9] followed by the partition number
Unsetting all partitions
Press [2][2]
Unsetting a selected partition
Press [2][9] followed by the partition number