RISCO Group 5IN2047 Agility3 Full User Manual UK.pdf - Manual (Page 22)

Agility 3 User Manual
Page 22
To listen in or talk:
1. From the Operations/Acknowledge menu, press [6]. The following messages are
announced:
“To Listen In press 1, To Talk press [2], To Listen and Talk (Open channel) press
[3], To return to the previous menu, Press [
 ].”
2. Select the desired option.
3. Press [  ] to end listening in and talking communication and return to the
Operations menu.
Bi-directional Audio Options after an Alarm
In the event of Burglary, Fire and Medical alarms, the Agility is able to report these events
and then stay on the line. This allows the Alarm Receiving Centre to perform Voice Alarm
verification, verify the alarm or Verification in order to verify a cause of event or guide
someone in distress.
Service call
The Service Call feature enables you to call the Alarm Receiving Centre by pressing a key.
To establish the service call, press the button on the main unit or press simultaneously the
buttons on the bi-directional keypad.
Note: The Service call should be defined by your engineer.
3.2 SMS Operation
SMS Remote Control
The Agility enables you to perform remote control operations using simple SMS
commands. The following section describes the SMS commands and the response of the
system to these commands.
Note: This application is available only if a GSM/GPRS module is installed in your system.
Operation SMS Message Structure Example
Set all partitions of
a user code [Code] S 1234S
Set all partitions to
Part set/Home
Setting [Code] P 1234P
Unset all partitions
of a user code [Code] U 1234U
Set by partition [Code] S [Partition No.] 1234S1
Part set by partition [Code] P [Partition No.] 1234P1