RISCO Group 5IN2047 Agility3 Full User Manual UK.pdf - Manual (Page 39)

Agility 3 User Manual
Page 39
Appendix B - Remote Control User Operations
The following section details the user operations from the Agility 2-Way Remote Control.
User operation can be defined to be activated by a quick mode or high security mode that
requires the use of a code.
Common Operations
Operation Quick High Security Mode 1
Full Set
> Code
Part Set
2
> Code
Full Unset
> Code
System Status
3
Long
4\?
Long
4\?
> Code
Output Control
4
A/B/C
Long / /
Long / / >
Code
Panic Alarm
+ simultaneously for 2 seconds
Clear Operation
5
>
Consult your engineer which commands are defined with a code.
Pressing > will cancel the Entry Delay time.
Pressing >
4\?
will give status indication only by the LED of the remote control and
not by local voice message.
Ask your engineer which device is assigned to which key.
Use this command to clear the remote control operation.
Advanced Operations
Operation Quick Code Sequence
Full Partition 1/2/3
Setting / / >
/ / > >
Code
Part Partition 1/2/3
Setting
/ / >
/ / > Code
Partition 1/2/3
Unsetting
/ / > / / > >