Epson PhotoPC 3100Z - Manual (Page 97)

Installing Software and Connecting 9-6
Connecting the Camera to Your
Computer
This section describes how to connect the camera to a USB-
compatible PC or Macintosh using the USB cable.
Note the following before you start:
◗ You can conserve battery life by using the optional AC
adapter while the camera is connected to your computer.
See page B-2 for instructions.
◗ When you connect the camera, make sure your system is
not exposed to sources of electromagnetic interference,
such as stereo speakers or the base units of cordless
telephones.
1 Locate the USB cable that came with the camera.
2 Plug the connector on the
USB cable into the USB
port on your computer, or
into a port on a USB hub.
NOTE
Although you can use a USB hub, it’s recommended that you
connect the camera directly to the computer’s USB port.
3 Open the connector cover on the side of the camera.
Then insert the connector on the other end of the USB
cable into the camera’s USB interface port.
4 Turn on your computer, then turn on the camera and
turn the camera dial to
.
/HJHQGERRN 3DJH  0RQGD\ $SULO     30