Roland V-800HD MKII Multi-Format Video Switcher - Manual (Page 11)

11
About Power Supply
Connect the included power cord to AC IN connector on rear panel. Be sure to use the included power cord for AC connection.
fig.ACconnection.eps
Depending on the circumstances of a particular setup, you may experience a discomforting sensation, or perceive that the
surface feels gritty to the touch when you touch this device, video cameras connected to it, or the metal portions of other objects,
such as projectors. This is due to an infinitesimal electrical charge, which is absolutely harmless. However, if you are concerned
about this, connect the ground terminal (see figure) with an external ground. When the unit is grounded, a slight hum may occur,
depending on the particulars of your installation. If you are unsure of the connection method, contact the nearest Roland Service
Center, or an authorized Roland distributor, as listed on the “Information” sheet.
fig.earth-terminal.eps
Unsuitable places for connection
• Water pipes (may result in shock or electrocution)
• Gas pipes (may result in fire or explosion)
• Telephone-line ground or lightning rod (may be dangerous in the event of lightning)
About the Ground Terminal
Power cord