Roland V-800HD MKII Multi-Format Video Switcher - Manual (Page 26)

26
Selecting the Output Format
When the procedure in “Inputting HDCP Signals” (p. 29) has been followed to set the HDCP mode to [ON], output from the SDI OUT, SD OUT, and
RGB/COMPONENT OUT connectors will be stopped. Note, however, that HDCP-applied output from the DVI-D/HDMI OUT connectors and output
to the multi-view monitor will continue.
About the Setting for the Output Format
This selects the format of the main output (digital) and analog outputs shown below. Signals that have different resolutions can
be output from digital and analog connectors.
fig.output-flow.eps
The [OUTPUT FORMAT] indicator for the format selected for the main output lights up. The corresponding output formats of the
SD, HD, and RGB indicators are as follows.
• SD 480i, 576i
• HD 480p, 576p, 720p, 1080i, 1080p
• RGB VGA (640x480) through WUXGA (1920x1200)
* By default, [HD] is selected, and the unit is set to output 1080i.
fig.format-indicator.eps
For information on the selectable output formats, refer to “About the Output Formats of the Connectors” on the following page.
RGB/Component
Format
Main Output Format
RGB/COMPONENT OUT SD OUT SDI OUT 1
PGM PVW AUX
Selector
DVI-D/HDMI
OUT 1
SDI OUT 2 DVI-D/HDMI
OUT 2
Composite
Format
Analog Output Format