Roland 6-Channel HD Video Switcher with Audio Mixer & PTZ Camera Control (1 RU) - Manual (Page 32)

32
Audio Operations
1. Select the [MENU] button 0 “AUDIO EMB.”
2. From among “AUDIO IN 1” through “AUDIO IN 5/6,”
select the input audio you want to send to the SDI
embedded-audio channel.
3. Use the [VALUE] knob to set the audio type to
“DRY” or “WET.”
Value Explanation
OFF No audio is sent.
DRY This sends the source audio with no effects applied.
WET This sends the effect-applied audio.
4. Press the [VALUE] knob to apply the setting.
Repeat steps 2 through 4 as needed.
5. Select “SDI OUT1 AUDIO” or “SDI OUT2 AUDIO,” then
use the [VALUE] knob to set it to “CH1–8.”
Audio containing channels 3 to 8 of embedded audio is output
from the SDI OUT connector set to “CH1–8.”
6. Press the [VALUE] knob to apply the setting.
7. Press the [MENU] button to quit the menu.