Roland 6-Channel HD Video Switcher with Audio Mixer & PTZ Camera Control (1 RU) - Manual (Page 7)

7
Panel Descriptions
Front Panel
6 7 9 10
8 11 12
1 2
5
4 3
# Name Explanation Page
1
AUDIO MIXER [1]–[5/6] knobs These adjust the volume level for AUDIO IN 1–5/6. p. 25
SIG/PEAK indicators This lights up when input via AUDIO IN 1–5/6 is detected, and when the volume level is too high. p. 25
2
[MASTER] knob This adjusts the level of the PGM/1 bus.
p. 26
AUDIO MIXER level meters This indicates the volume level of the PGM/1 bus.
3
USB MEMORY port
Refer to the “USB MEMORY port” (p. 9),“PHONES jack” (p. 9), and “[PHONES] knob” (p. 9). PHONES jack
[PHONES] knob
4 [AUTO MIXING] button
This switches the Auto Mixing feature on and off. When the feature is turned on, the [AUTO
MIXING] button lights up in green.
p. 29
5 Built-in display According to the setting of the [SW MODE] button, this indicates the current status. —
6
[MENU] button
This switches between displaying or hiding the menu. The menu is shown both on this unit’s
display and on the multi-view monitor (p. 10) that’s connected to the HDMI OUT 3 connector.
* To show the menu from the HDMI OUT 3 connector, set “OUTPUT ASSIGN” (p. 16) to “MULTI-
VIEW.”
p. 11
[EXIT] button This returns you to the menu one level higher.
[VALUE] button
Turning: This selects a menu item or changes a setting value.
Pressing: This accepts the selected menu item or applies changes to a setting. It also executes
operations.
7 [SW MODE] button This switches the functioning of the Cross Point [1]–[8] buttons. —
8 [FREEZE] button This stops (freezes) input video. When on, this is lit red. p. 19
9 Cross-point [1]–[8] buttons
The function of these buttons changes depending on the color of the [SW MODE] button. —
[SW MODE]
button color
Explanation
Yellow The buttons select the video that is output to the PGM/1 or PVW/2 bus.
p. 17
Green The buttons select the video that is output to the AUX/3 bus.
Blue The buttons recall preset memories. p. 33
Pink The buttons are used by the GPO and camera control functions. p. 36
10 [TAKE] button
This button outputs the video of the PVW/2 bus to the PGM/1 bus.
* This is available only in PGM-PST mode (p. 17).
p. 17
The video from PinP or split is output to the PGM/1 bus.
p. 22
p. 23
11 [PinP] button
This switches PinP or split video composition on and off.
* In MATRIX mode (p. 18), this button selects the channel 7 video of the PVW/2 bus.
p. 22
12 [DSK] button
This switches DSK composition on or off.
* In MATRIX mode (p. 18), this button selects the channel 8 video of the PVW/2 bus.
p. 27