Home Dynamix ANEXX A - Manual (Page 172)

4 Ports 11g Wireless ADSL2/2+ Router 165
5. LAN (Link/Act) LED does not light up.
Ans. Check the following:
1. Make sure that the LAN cables are securely connected to the 10/100Base-T port.
2. Make sure that you are using the correct cable type for your Ethernet equipment.
3. Make sure the computer's Ethernet port is configured for auto-negotiation.
6. Failed to configure the 4 Ports 11g Wireless ADSL2/2+ Router through web browser ( By a client
PC in LAN )
Ans. Check the following:
1. Check the hardware connection of the 4 Ports 11g Wireless ADSL2/2+ Router’s LAN port. The LED
will lit when a proper connection is made.
2. Check your Windows TCP/IP setting (Refer to Chapter 3 for setting details).
3. Open the Windows System Command Prompt:
„ For Windows 9x/ME: Manually enter winipcfg, then press Enter.
„ For Windows 2000/XP: Manually enter ipconfig/all, then press Enter.
4. You should have the following information listed on your Window System:
„ IP Address: 192.168.1.x
„ Submask: 255.255.255.0
„ Default Gateway IP: 192.168.1.1
7. I forgot or lost my Administrator Password.
Ans. Reset the 4 Ports 11g Wireless ADSL2/2+ Router to factory default by pressing the “Reset” button for
10 seconds.
If you are still getting prompted for a password when saving settings:
1. A ccess the Router’s web interface by going to http://192.1681.1.
2. Enter the default “username” and “password” then click “Enter” to log in.
3. Click on “TOOLS” then click “User Management”.
4. Enter a new “Password” and new “Username” in the “Username” and “Password” field, and
enter the same password in the second field to confirm the password.
5. Click “Apply” after your setting.
8. I need to upgrade the Firmware.
Ans. Check with your local dealer for technical support before upgrading your 4 Ports 11g Wireless
ADSL2/2+ Router. Before proceed the upgrading process, check the following details:
1. Download the latest Firmware and save at your pointed location.
2. Read the firmware release note carefully before proceed the upgrading process.
3. Refer to TOOLS → Update Gateway section for the upgrading process.