Home Dynamix ANEXX A - Manual (Page 75)

4 Ports 11g Wireless ADSL2/2+ Router 68
4.3.3 LAN Setup - Ethernet Switch
The Ethernet Switch page allows you to set the LAN port into the following modes (Default is “Auto”).
Ethernet Switch port settings can be configured to meet the requirements of your LAN configuration.
„ Auto: The 4 Ports 11g Wireless ADSL2/2+ Router will automatically sense which mode to use,
selecting between 100 Mbps Full Duplex, 100 Mbps Half Duplex, 10 Mbps Full Duplex, and 10
Mbps Half Duplex. Default setting is “Auto”.
„ 10/Half Duplex: Data cannot be transferred and received at the same time. For example, data can
be sent, and once the transmission is complete, data can be received. This is done at a transfer
rate of 10Mbps.
„ 10/Full Duplex: Data can be transferred and received simultaneously at the transfer rate of
10Mbps.
„ 100/Half Duplex: Data cannot be transferred and received at the same time. For example, data
can be sent, and once the transmission is complete, data can be received. This is done at a
transfer rate of 100Mbps.
„ 100/Full Duplex: Data can be transferred and received simultaneously at the transfer rate of
100Mbps.
„ Apply: Click Apply to complete the setting.
„ Cancel: Click Cancel to ignore all the changes.
„ To complete and save the setting, click Save All after clicking the Apply button.