Home Dynamix ANEXX A - Manual (Page 58)

4 Ports 11g Wireless ADSL2/2+ Router 51
4.3.1.1.4.1 DHCP Configuration Procedures
1. From the Setup main page, click on New Connection.
2. Enter a unique name for the Static connection in the Name field. The name must not have spaces and
cannot begin with numbers.
3. At the Type field select DHCP. The DHCP connection setup page is displayed as shown below.
4. The Network Address Translation (NAT) and the Firewall options are enabled by default. Leave these in
the default mode.
5. If your ADSL line is connected and your ADSL/IPS provider is supporting DHCP, you can click the
Renew button and the gateway will retrieve an IP address, Subnet mask, and Gateway address.
At anytime, you can release the DHCP address by clicking on the Release button, and renew the DHCP
address by clicking on the Renew button.
6. Under PVC Settings, enter the values of VPI and VCI settings.
Note—Your DSL service provider or your ISP will supply these.
7. Select the Quality of Service (QOS); leave the default value if you are unsure or the ISP did not
provide this information.
8. Click the Apply button to complete the connection setup. This will temporarily save this connection as
illustrated in figure below. A new link has been created for this connection in the left-hand column. You
can Apply/Delete/Cancel this connection using this screen.
9. To make the change permanent , click on Save All.
10. To check on the status, click on Status (at the top of the page) and select Connection Status.