Home Dynamix ANEXX A - Manual (Page 64)

4 Ports 11g Wireless ADSL2/2+ Router 57
4.3.1.1.6.1 CLIP Configuration Procedures
1. From the Setup main page, click on New Connection.
2. Enter a unique name for the Static connection in the Name field. The name must not have spaces and
cannot begin with numbers.
3. At the Type field select CLIP. The CLIP connection setup page is displayed as shown in figure below.
4. The Network Address Translation (NAT) and the Firewall options are enabled by default. Leave these in
the default mode.
5. Based upon the information your ADSL/ISP provided, enter your assigned IP address, Mask, ARP
server, and Default Gateway.
6. Under PVC Settings, enter the values of VPI and VCI settings.
Note: Your DSL service provider or your ISP will supply these.
7. Select the quality of service (QOS); leave the default value if you are unsure or the ISP did not provide
this information.
8. Click the apply button to complete the connection setup. This will temporarily save this connection as
illustrated in figure below. A new link has been created for this connection in the left-hand column. You
can Apply/Delete/Cancel this connection using this screen.
9. To make the change permanent , click on Save All.
10. To check on the status, click on Status (at the top of the page) and select Connection Status.