Home Dynamix ANEXX A - Manual (Page 47)

4 Ports 11g Wireless ADSL2/2+ Router 40
4.3.1.1.1.1 PPPoE Configuration Procedures
1. From the CONFIG main page, click on New Connection.
2. Enter a unique name for the PPPoE connection in the Name field. The name must not have spaces
and cannot begin with numbers.
3. Select PPPoE from the Type drop down manual.
4. The Network Address Translation (NAT) and the Firewall options are enabled by default. Leave these
in the default mode.
Note—NAT enables the IP address on the LAN side to be translated to IP address on the WAN side. If
NAT is disabled, you will not be able to go outside.
5. Under PVC Settings, enter the values of VPI and VCI settings.
Note—Your DSL service provider or your ISP will supply these.
6. Select the quality of service (QoS). Leave the default value if you are unsure or the ISP did not provide
this information.
7. Click the Apply button to complete the connection setup. This will temporarily save this connection as
illustrated in below. A new link has been created for this connection in the left-hand column. You can
Connect/Disconnect/Apply/Delete/Cancel this connection using this screen.
8. To make the change permanent, click on Save All.
9. To check on the connection status, click on Status (at the top of the page) and select Connection
Status.