Hughes SATELLITE HN9000 - Manual (Page 94)

• Satellite Interface Statistics – Contains information on the receive status and signal strength,
as well as error messages related to satellite modem receive information.
• Traffic Statistics: Receive – Contains statistical information on data received from the
satellite including number of packets received or dropped, etc.
Typical values for Reception Information parameters
The following table lists typical values and the range of values for parameters on the Reception
Information page. This information may help you understand the values displayed by a customer's
satellite modem.
To see the definition of any parameter, click the parameter name on the screen.
Table 12: Reception Information parameters – typical values and range
Range of values Typical values Parameter
Satellite Interface Statistics (parameter category)
Up – The modem is receiving
signals from the satellite.
Up Receive Status
Down – The modem is not receiving
signals from the satellite.
0–255. 160–220 Receive Signal Strength
4.5–18.0. 16 CONUS SNR
4.5–18.0. 14 PTP SNR
Not applicable (parameter reserved
for future use). OK Receive Path Fault
Any whole number. 0 RX Error
Traffic Statistics: Receive
Any whole number. 0 Total Satellite Packets Received
Any whole number. 0 CONUS Packets Received
Any whole number. 0 PTP Packets Received
Any whole number. 0 Unicast Data IP Datagrams
Any whole number. 0 Multicast IP Datagrams
Any whole number. 0 Management and Signaling IP
Datagrams
Any whole number. 0 Satellite Packets Dropped
Any whole number. 0 Frames With No Signal
Any whole number. 0 Number of TIPS Received
Red flags on Reception Information page
A red flag next to a value on the Reception Information page indicates a problem related to the
parameter listed in the same row where the flagged value appears. For explanation, find the
HN9000 Satellite Modem Installation Guide
78
1037576-0001 Revision E
System Control Center Chapter 9