Harley-Davidson RIDE-ON 74287 - Manual (Page 10)

Battery Charging
TM
Pb
• Plug the charger connector into the battery .
• Plug the charger into a standard 120 volt wall outlet .
Note: If power flow to the wall outlet is controlled by a
switch, make sure the switch is “ON”.
• Before first-time use, charge the battery for at least 18
hours. Never charge the battery longer than 30 hours.
• Recharge the battery for at least 14 hours after each
use of your vehicle. Do not charge the battery longer
than 30 hours.
• Once the battery is charged, pull firmly on the charger
connector to disconnect it from the battery. Unplug the
charger from the wall outlet. The battery is now ready to
be installed in your vehicle. Please see the Battery
Installation section on page 28 for detailed instructions on
installing your battery. If your battery is already installed in
your vehicle, simply plug the motor harness connector
into the battery and replace the seat.
11 2
11 1
• Using a Phillips screwdriver, loosen the two screws
holding the battery clamp to the vehicle body.
• Remove the screws and the battery clamp. Set the
battery clamp and screws aside. Do not throw out the
battery clamp or screws. You will use them when installing
your battery (see page 28).
• Remove the battery from the battery compartment.
• Remove and discard any cardboard in battery compart-
ment which may have been added for shipping purposes.
Battery
Charger
Connector
Battery
Battery
Clamp
11 1
11
2
10
1 2