Assembly, Warning – Harley-Davidson RIDE-ON 74287 User Manual
Page 11
Assembly
• Position the taillight cover with the inside arrow
pointing upward.
• Fit the taillight cover to the taillight.
• Insert two #8 x
1
/
2
" screws through the holes in the
taillight cover and into the taillight.
• Tighten the screws with a Phillips screwdriver.
Do not over-tighten.
• Position the vehicle body upside down on a flat surface.
• Fit the taillight to the outside of the vehicle body rear
fender, as shown. Make sure the holes in the vehicle
body rear fender and taillight are aligned.
• First, insert one #8 x
1
/
2
" screw through the hole near the
edge of the vehicle body rear fender and into the taillight.
• Next, insert two #8 x
3
/
4
" screws through the remaining
holes in the vehicle body rear fender and into the taillight.
• Tighten the screws with a Phillips screwdriver.
Do not over-tighten.
Taillight
Cover
Arrow
Points Up
Taillight
Vehicle Body
Rear Fender
Taillight
#8 x
1
/
2
" Screw
#8 x
3
/
4
" Screw
#8 x
3
/
4
" Screw
F
Children can be harmed by small parts, sharp edges and sharp points
in the vehicle’s unassembled state, or by electrical items. Care should be taken
in unpacking and assembly of the vehicle. Children should not handle parts,
including the battery, or help in assembly of the vehicle.
WARNING
TM
• Lift to remove the vehicle body from the vehicle frame.
Vehicle
Frame
Vehicle
Body
11
1
3
2