Problems and solutions guide, Problem possible cause solution – Harley-Davidson RIDE-ON 74287 User Manual

Page 33

Advertising
background image

Problem

Possible Cause

Solution

Vehicle does not run

Undercharged battery

Charge the battery. A new battery should have been
charged for at least 18 hours before using the vehicle for
the first time. After first-time use, recharge the battery for
at least 14 hours after each use. Never charge the battery
longer than 30 hours.

Check all connectors. Make sure the battery connector is
tightly plugged into the battery, and that the charger is
plugged into the wall.

Make sure power flow to the wall outlet is “ON”.

Charger is not working

There is no sure way to tell if your charger is working unless
you have a volt meter. If you suspect there is a problem with
your charger, contact your local Power Wheels

®

authorized

service center. They can test your charger for you.

Tripped thermal fuse

Each Power Wheels

®

12 volt battery has a built-in thermal

fuse. A thermal fuse may "trip" and shut down operation of
the vehicle if the vehicle is overloaded or the driving
conditions too severe. The fuse will automatically reset itself
after approximately 25 seconds, allowing the vehicle to
resume normal operation. To avoid repeated automatic
shutdowns, do not overload the vehicle by exceeding the
65 lb maximum weight capacity or by towing anything behind
the vehicle. Do not drive up hills or run into fixed objects,
which can cause the wheels to stop spinning while power
is still being supplied to the motors. If a thermal fuse
continually trips, contact your local Power Wheels

®

authorized

service center.

Loose wire or loose connectors

Check all wires and connectors. Make sure the motor
harness connector is tightly plugged into the battery and that
there are no loose wires around the motors.

Dead batteries

If your battery is old or if you have not followed Battery
Care instructions, your battery may be dead. If you are
unsure whether or not the battery are dead, you can have
them tested at your local Power Wheels

®

authorized

service center.

Electrical switch damage

The electrical switches can become corroded due to
exposure to water or moisture, or can jam due to loose dirt,
sand or gravel. Contact your local Power Wheels

®

authorized

service center for diagnosis and repair.

Motor damage

Contact your local Power Wheels

®

authorized service center

for diagnosis and repair.

IMPORTANT!

If you experience a problem with your vehicle, first check the Problems and Solutions

Guide below. If you still experience a problem, please contact Power Wheels

®

Consumer Relations,

toll-free at

1-800-348-0751

between 8 AM and 6 PM (EST) Monday through Friday. Or, contact your

local Power Wheels

®

authorized service center. For the location nearest you, please refer to the

Authorized Service Center list beginning on page 36, or register on-line at www.powerwheels.com.

Problems and Solutions Guide

O

33

Advertising