Harley-Davidson RIDE-ON 74287 - Manual (Page 25)

Assembly
• Turn the vehicle upright.
• Fit the fender tip onto the front of the fender.
• Insert two #8 x 3 /
4
" screws through the fender tip and into
the vehicle frame.
• Tighten the screws with a Phillips screwdriver.
Do not over-tighten.
Vehicle
Frame
Fender Tip
Front
Fender
Round
Bushing
• Fit a round bushing, ring side first, between the wheel
and the shock.
Shock
.437 (Large
Diameter)
Cap Nut
Wheel
Axle
Ring Side
• Fit two hex bushings into the center hole in the
remaining wheel.
• While holding the hex bushings in place, position the
wheel between the shocks.
• Continue to slide the wheel axle through the wheel.
Shock Shock
Wheel (with Hex Bushings)
Wheel Axle
Hex Bushings
Hint: You may need to push the shock outward slightly to
fit the round bushing.
• Continue to slide the wheel axle through the round
bushing and then the shock.
• Fit a .437 (large diameter) cap nut on the end of the
wheel axle.
• Support the opposite end of the wheel axle and tap the
cap nut with a hammer to secure it on the end of the
wheel axle.
• Pull on the .437 cap nut to make sure the front wheel
assembly is secure.
.437"
.437 Cap Nut Round Bushing
25
52
53
54