Harley-Davidson RIDE-ON 74287 - Manual (Page 22)

• Insert the handlebar harness into
the wire clip on the side of the
vehicle body.
Assembly
• Loosen the screw in the sound box battery compartment
door using a Phillips screwdriver and open the battery
compartment.
• Insert three “AA” (LR6) alkaline batteries in the sound
box as indicated in the battery compartment.
Hint: For longest battery life, use only alkaline batteries.
• Close the battery compartment door and tighten the
screw using a Phillips screwdriver. Do not over-tighten.
Sound Box
Battery
Compartment
Battery
Compartment
Door
SHOWN ACTUAL SIZE
1.5V x 3
“AA” (LR6)
Battery Tips
• Do not mix old and new batteries.
• Do not mix different types of batteries: alkaline, standard
(carbon-zinc) or rechargeable (nickel-cadmium).
• Remove the batteries during long periods of non-use.
Always remove exhausted batteries from the sound box.
Battery leakage and corrosion can cause damage.
Dispose of batteries safely.
• Never short circuit the battery terminals.
• Non-rechargeable batteries are not to be recharged.
• Only batteries of the same or equivalent type as
recommended in these instructions are to be used.
• If removable rechargeable batteries are used, they are
only to be charged under adult supervision.
• Rechargeable batteries are to be removed from the
sound box before they are charged.
• If you use a battery charger, it should be examined
regularly for damage to the cord, plug, enclosure and
other parts. Do not use a damaged battery charger until
it has been properly repaired.
• When sound from the vehicle becomes faint, or if the
sound stops working, it’s time to replace the batteries.
TM
Wire
Clip
Handlebar
Harness
See
Inset
Wire
Clip
Handlebar
Harness
22
43 44