Hayes Microcomputer Products DIVA T/A - Manual (Page 46)

DIVA T/A PC Card User’s Guide 46
Using the VT100 Configuration Tool
This section describes how to use the VT100 Configuration Tool to
configure your DIVA T/A under DOS and OS/2. The VT100
Configuration Tool is incorporated in the DIVA T/A firmware. It lets
you configure basic ISDN-specific parameters.
Note: When using DOS, make sure that DOS Card services is
installed and working. Use the DOS Card Services to record the COM
Port, IRQ, and Port address assigned to your PC Card slot.
To activate the VT100 Configuration tool:
1 Start the VT100-compatible terminal-emulation program. Set up
your VT100 terminal-emulation program (for example, Telix or
HyperAccess), using the table below as a guideline:
Parameter Setting
Terminal Emulation Type VT100/VT102
Local Echo Off
CR Translation CR
LF after CR Off
2 Verify that the terminal emulation program uses the same COM
port as that assigned to the DIVA T/A.
3 Enter the following command at the prompt and press Enter:
AT@MENU
The main VT100 Configuration Tool screen opens:
*-----------------------------------------------------------------------------*
| DIVA T/A - North American Version 1.5.1 |
| Copyright (c) 1997 Eicon Technology Corporation |
+-------------------------------------------------------------+---------------+
|MENU: Main menu |Choice: |
| |Current profile|
| Open Profile: Current profile |Profile 0 |
| |Profile 1 |
| Primary ISDN Param.: < press Enter > |Profile 2 |
| Alternate ISDN Param.: < press Enter > |Factory profile|
| | |
| Protocol: Multilink PPP | |
| Advanced: < press Enter > | |
| Powerup Profile: Profile 0 | |
| Save Profile: Profile 0 | |
| Restart Card: Profile 0 | |
| Quit | |
|<ESC> Quit | |
+-----------------------------------HELP----------------------+---------------+
| Selects which profile to open: current, stored (0,1,2) or factory. |
| -Loads the current profile. |
| |
| |
*-----------------------------------------------------------------------------*