Hayes Microcomputer Products DIVA T/A - Manual (Page 49)

DIVA T/A PC Card User’s Guide 49
The following parameters must be configured for the Primary
and optionally, the Alternate location:
Parameter Description
Switch Type Specifies the ISDN switch type used by
your ISDN service provider.
North America firmware: For most
locations, Auto-detect should be used. If
the ISDN Switch Type cannot be
automatically detected, specify National
ISDN-1 (NI-1) or AT&T (5ESS).
International (Excluding North America)
firmware: Europe (Euro ISDN), Japan
(INS-Net64), and Australia (TPH1962).
Note: Australia has two different switch
types available: TPH1962 and EuroISDN.
Check with your ISDN provider for more
information on how to set your switch type.
Service Profile
Identifier (SPID)
(1st/2nd Number) Applies to North American firmware only.
Service Profile Identifier (SPID). A
number, specified by your ISDN provider,
which identifies your ISDN equipment to
the switch, and in most instances, is
automatically detected with AutoSPID. For
more information on AutoSPID, refer to
page 76.
Directory Number
(1st/2nd Number) Specifies your ISDN number(s). You can
specify either one or two ISDN numbers
(1
st and 2 nd ). Specify two numbers if your
ISDN provider assigns two different
numbers.
In most instances, Directory Numbers will
be automatically detected with AutoSPID.
For more information on AutoSPID, refer
to page 76.