HP 220 - Manual (Page 118)

25 Set the carriage assembly upsideĆdown on a flat surface.
26 Using a small, standard screwdriver, remove the left and right belt clamps from the
carriage assembly.
Belt clamp
27 Remove the main drive belt from the carriage assembly.
Main drive belt
C A U T I O N
Be careful not to damage the clamps.
Calibration: After having reassembled the plotter, perform the cartridgeĆalignment
routine D chapter 7.
Reassembling: Correctly install the
clamps, so that they don't fall out during
plotter operation!
6Ć54 Removal and Replacement C3187Ć90000