HP 220 - Manual (Page 83)

Reassembling: When replacing screws on any plastic part, always begin
by gently twisting the screw in anticlockwise with your hand, until the
screw finds the thread path and clicks, and then twisting the screw in
clockwise with your hand, before using a screwdriver. This is to avoid
crossĆthreading. Do not overĆtighten the screws.
5 Remove the three screws from the right
side of the right endcover.
1 Remove the window D page 6Ć15, and the center cover D page 6Ć16.
2 Remove the two screws on the right front trim and the two screws on the right back trim.
C A U T I O N
Torx-15
Torx-15
3 If the plotter is attached to a plotter
stand, loosen the tworightĆhand screws
that attach the plotter to the stand.
4 Maintaining an even pressure on the top
and bottom of the endcover, pull it to the
right, away from the plotter.
Do not let the windowĆpivot spring drop out
of the endcover
C A U T I O N
Do not stress or apply pressure to the
frontĆpanel assembly.
0D2 DmbtinJ: Note the upper and lower
grooves the endcover engages on the front
panel
6Ć19 Removal and Replacement C3187Ć90000
Removing the Right Endcover