HP 220 - Manual (Page 96)

Do not force the cable out of its clamp. First pull the clamp gently towards
you to release the cable; then pull the cable easily out of the clamp.
1 Remove the electronicsĆenclosure
cover ' page 6Ć5.
2 Remove the window ' page 6Ć15.
3 Remove the center cover ' page 6Ć16.
4 Remove the right endcover ' page 6Ć19.
5 Take note of the correct positioning of
the frontĆpanel cable for reassembling.
Incorrect positioning could cause
obstruction of the cartridge carriage or
motor gears.
6 Unclip the windowĆsensor cable and
frontĆpanel cable from their holding clip
on the underside of the frontĆpanel
assembly.
7 Release the frontĆpanel cable from its clamp on the main PCA, and from its holding clip on
the right side of the plotter.
C A U T I O N
Do not release the frontĆpanel cable from its clamp on the frontĆpanel PCA
Front-panel
connector clamp
Clip
Window-sensor
cable
Front-panel
cable
6Ć32 Removal and Replacement C3187Ć90000
Removing the FrontĆPanel Assembly