HP 220 - Manual (Page 93)

1 Remove the electronicsĆenclosure
cover D page 6Ć5.
2 Remove the window D page 6Ć15.
3 Remove the center cover D page 6Ć16.
4 D/A1Ćsize plotters only: Open the
flexible, DANGER HIGH VOLTAGE,
insulation cover.
5 Disconnect the trailingĆcable connector
from the main PCA.
6 Remove the two screws that attach the
toroidto the rear of the electronics
enclosure.
Flex the cover to open it. Do not detach
the cover from the plotter.
Trailing-cable
connector
7 Pull off the two endcaps of the toroid and
remove the toroidfrom the trailing cable.
Torx-10
If you are installing a new trailing cable,
make sure the main PCA is compatible
with it. (Details D chapter 9.)
6Ć29 Removal and Replacement C3187Ć90000
Removing the Trailing Cable