HP 220240 - Manual (Page 87)

You can access some menu features by using commands from the host
computer; you can select others only from the control panel. This chapter
describes how to select features using the control panel. For information
about selecting features using commands from the host computer, see
the Digital ANSI-Compliant Printing Protocol Level 3 Programming
Reference Manual and the Digital ANSI-Compliant Printing Protocol Level
3 Programming Supplement.
NOTE:
The interface, message, and page offset features can be configured
only from the control panel.
4.1 Entering Menu Mode
You configure the printer by selecting certain parameters (features and
values) while in Menu Mode. When the printer is in Menu Mode, the keys
labeled with gray text and symbols function to select parameters from the
menu. Table 4–1 shows how to enter Menu Mode.
NOTE:
With the exception of
On Line
, all keys operate only when the printer
is off line.
Table 4–1: Entering Menu Mode
Operation Display Reads
1. Press
On Line
to place the
printer off line.
— The On Line indicator
shuts off.
00 READY
2. Press
Menu
to place the
printer in Menu Mode.
— The printer is now in Menu
Mode and the keys
labeled with gray text
and symbols operate.
FONT/FEED LAYOUT
4–2 Operator’s Guide