HP 220240 - Manual (Page 96)

4.4.1 Sample Procedure for Changing and Saving Values
This section contains an example of how to change and save values in Menu
Mode. Use the steps in Table 4–6 to perform the following tasks:
• Enter Menu Mode
• Change page offset values of X and Y in the LAYOUT menu
from
✂✁☎✄ ✁
to
✆✞✝✟✁☎✄ ✁
• Save the new values in NVRAM
• Exit Menu Mode
Before You Begin
This example assumes that the printer is using the factory default values
in ROM. You will use Test Print A to verify the changes you make. Print a
copy of Test Print A before beginning this example (Section 2.13). Be sure
that all printing has stopped and the display reads 00 READY before you
make any changes.
Table 4–6: Changing and Saving Values
Operation Display Reads
1. Press
On Line
to place the
printer off line.
— The On Line indicator
shuts off.
00 READY
2. Press
Menu
to place the
printer in Menu Mode.
FONT/FEED LAYOUT
3. Press
✁
once to scroll
the display to the
LAYOUT menu.
LAYOUT COPY/OVER
4. Press ✂ Enter
to enter
the LAYOUT menu.
offsetX offsetY
5. Press ✂ Enter
to select
the offsetX feature.
offsetX =+ 0.0
Printer Configuration 4–11