Hoshizaki KM-260BAH User Manual

Page 78

Advertising
background image

73

6) Pour the cleaning solution into the water tank. Move the control switch to the

“SERVICE” position and the service switch to the “WASH” position. Close the door.

7) After 30 minutes, move the control switch to the “OFF” position.

8) Same as step 4.

9) Move the control switch to the “ICE” position to fi ll the water tank with water.

10) After 3 minutes, move the control switch to the “SERVICE” position and the service

switch to the “WASH” position.

11) After 5 minutes, move the control switch to the “OFF” position.

12) Same as step 4.

13) Repeat steps 9 through 12 three more times to rinse thoroughly.

14) Disconnect the overflow pipe. Next, remove the water tank by removing the two

thumbscrews and pulling the tank towards you slightly and pushing it down. Be
careful to avoid breakage when handling the parts. See Fig. 17.

15) Pull the cube guides (quantity varies depending on model) upward to remove them

from the water tank. They are snapped in place. See Fig. 18.

16) Same as step 1.

17) Wash the bin control switch, water tank, fl oat switch, cube guide and overfl ow pipe

by using a nylon scouring pad, brushes and the cleaning solution. In addition to the
removed parts, also wash the bin liner and bracket (L) (R) with the solution.

18) Discard the cleaning solution and rinse the parts thoroughly with water.

[b] SANITIZING PROCEDURE - Following Cleaning Procedure

1) Dilute approximately 0.5 fl. oz. (15 ml) of a 5.25% sodium hypochlorite solution

(chlorine bleach) with 1 gal. (3.8 lit.) of warm water. Using a chlorine test strip or
other method, confi rm that you have a concentration of about 200 ppm.

2) Soak the removed parts from step 17 above in a clean container containing the

sanitizing solution. After allowing the parts to soak for 10 minutes, wash them with
the solution. Also wash the bin liner, bracket (L) (R) with the solution.

3) Discard the sanitizing solution and rinse the parts thoroughly with water.

4) Replace the removed parts in their correct positions in the reverse order of which

Advertising
This manual is related to the following products: