Document Outline

• DS457 Integration Guide
  • Warranty
  • Revision History
• Table of Contents
• About This Guide
  • Introduction
  • Configurations
  • Chapter Descriptions
  • Notational Conventions
  • Related Documents
  • Service Information
• Getting Started
  • Overview
    • DS457 Features
  • Theory of Operation
    • DS457 Block Diagram Descriptions
    • DS457 Decoder/Interface Board
• Installation
  • Overview
  • Unpacking
  • Mounting
    • DS457 Mounting Dimensions
    • Mounting the Imager on the Gooseneck Stand
    • Mounting the Imager on the POS Stand
    • Mounting the Imager on the MS320X Conversion Mounting Bracket
  • Connecting the DS457
    • USB Host Connection
    • Serial Host Connection
    • Trigger Jack Connector Pins
  • Location and Positioning
  • Embedded Applications Requiring a Window
    • Window Material
    • Window Coatings
    • Embedded Window Angle and Position
  • Recommended Exit Window Information
    • Exit Window Notes
  • Accessories
    • Simple Serial Interface Software Developer's Kit (SSI SDK)
    • Motorola SNAPI Software Developer's Kit
• Imaging
  • Overview
  • Imaging System
    • Aiming Pattern
    • Aiming Error
    • Aiming Control
    • Illumination System
    • Illumination Control
    • Frame Rate Control
  • Capturing Data
  • Beeper and Decode LED Indications
  • Supported Symbologies
  • Operating Modes
• Specifications
  • Electrical Interface
  • Dimension Drawings
  • DS457 Imager Technical Specifications
    • Skew, Pitch and Roll
  • Decode Zones
    • DS457-SR/DL
    • DS457-HD/DP
• Maintenance & Troubleshooting
  • Overview
  • Maintenance
    • Cleaning the Connector
  • Troubleshooting
• User Preferences
  • Introduction
    • Host Selection
    • Phantom Scan Session
  • Changing Default Values
  • Scanning Sequence Examples
  • Errors While Scanning
  • User Preferences Parameter Defaults
  • User Preferences
    • Set Default Parameter
    • Parameter Scanning
    • User Parameter Pass Through
    • Beep After Good Decode
    • Beeper Tone
    • Beeper Volume
    • Suppress Power-up Beeps
    • Trigger Mode
    • Motion Enhancement for Presentation Mode
    • Power Mode (RS-232 Hosts Only)
    • Time Delay to Low Power Mode
    • Picklist Mode
    • Decode Session Timeout
    • Timeout Between Decodes, Same Symbol
    • Continuous Bar Code Read
    • Mirrored Image
    • Mobile Phone/Display Mode
    • Validate Concatenated Parameter Bar Codes
    • PDF Prioritization
    • PDF Prioritization Timeout
    • Multicode Mode
    • Multicode Expression
    • Multicode Troubleshooting
• Imager Preferences
  • Introduction
  • Scanning Sequence Examples
  • Errors While Scanning
  • Imager Preferences Parameter Defaults
  • Imager Preferences
    • Operational Modes
    • Decoding Autoexposure
    • Decoding Illumination
    • Decode Aiming Pattern
    • Aim Brightness
    • Illumination Brightness
    • Low Light Enhancement
    • Presentation Mode Field of View
    • Frame Rate
    • Image Capture Autoexposure
    • Image Capture Illumination
    • Fixed Gain
    • Exposure Time
    • Snapshot Mode Timeout
    • Snapshot Aiming Pattern
    • Presentation Snapshot by Motion
    • Continuous Snapshot
    • Image Cropping
    • Crop to Pixel Addresses
    • Image Resolution
    • Image Brightness (Target White)
    • Image File Format Selector
    • JPEG Image Options
    • JPEG Quality and Size Value
    • Image File Meta Data
    • Image Enhancement
    • Image Edge Sharpening
    • Image Contrast Enhancement
    • Image Rotation
    • Bits per Pixel
    • Signature Capture
    • Signature Capture File Format Selector
    • Signature Capture Bits per Pixel
    • Signature Capture Width
    • Signature Capture Height
    • Signature Capture JPEG Quality
    • Video View Finder
    • Target Video Frame Size
    • Video View Finder Image Size
    • Video Resolution
• SSI Interface
  • Introduction
  • Communications
  • SSI Transactions
    • General Data Transactions
    • Transfer of Decode Data
  • Communication Summary
    • RTS/CTS Lines
    • ACK/NAK Option
    • Number of Data Bits
    • Serial Response Time-out
    • Retries
    • Baud Rate, Stop Bits, Parity, Response Time-out, ACK/NAK Handshake
    • Errors
  • Things to Remember When Using SSI Communication
  • Using Time Delay to Low Power Mode with SSI
  • Simple Serial Interface Default Parameters
  • SSI Host Parameters
    • Select SSI Host
    • Baud Rate
    • Parity
    • Check Parity
    • Software Handshaking
    • Host RTS Line State
    • Decode Data Packet Format
    • Host Serial Response Time-out
    • Host Character Time-out
    • Multipacket Option
    • Interpacket Delay
  • Event Reporting
    • Decode Event
    • Boot Up Event
    • Parameter Event
• Serial Interface
  • Introduction
  • Serial Parameter Defaults
  • Serial Host Parameters
    • Serial Host Types
    • Baud Rate
    • Parity
    • Data Bits
    • Check Receive Errors
    • Hardware Handshaking
    • Software Handshaking
    • Host Serial Response Time-out
    • RTS Line State
    • Beep on <BEL>
    • Intercharacter Delay
    • Nixdorf Beep/LED Options
    • Ignore Unknown Characters
  • ASCII Character Set for Serial Hosts
• USB Interface
  • Introduction
  • USB Parameter Defaults
  • USB Host Parameters
    • USB Device Type
    • Symbol Native API (SNAPI) Status Handshaking
    • USB Country Keyboard Types (Country Codes)
    • USB Keystroke Delay
    • USB CAPS Lock Override
    • USB Ignore Unknown Characters
    • Emulate Keypad
    • Emulate Keypad with Leading Zero
    • USB Keyboard FN1 Substitution
    • Function Key Mapping
    • Simulated Caps Lock
    • Convert Case
    • USB Static CDC
  • ASCII Character Set for USB
• OCR Reading
  • Introduction
  • OCR Parameter Defaults
  • OCR Parameters
    • Enable/Disable OCR-A
    • OCR-A Variant
    • Enable/Disable OCR-B
    • OCR-B Variant
    • Enable/Disable MICR E13B
    • Enable/Disable US Currency Serial Number
    • OCR Orientation
    • OCR Lines
    • OCR Minimum Characters
    • OCR Maximum Characters
    • OCR Security Level
    • OCR Subset
    • OCR Quiet Zone
    • OCR Bright Illumination
    • OCR Template
    • OCR Check Digit Modulus
    • OCR Check Digit Multiplier
    • OCR Check Digit Validation
• Symbologies
  • Introduction
  • Scanning Sequence Examples
  • Errors While Scanning
  • Symbology Parameter Defaults
  • Disable All Symbologies
  • UPC/EAN
    • Enable/Disable UPC-A
    • Enable/Disable UPC-E
    • Enable/Disable UPC-E1
    • Enable/Disable EAN-8/JAN-8
    • Enable/Disable EAN-13/JAN-13
    • Enable/Disable Bookland EAN
    • Decode UPC/EAN/JAN Supplementals
    • User-Programmable Supplementals
    • UPC/EAN/JAN Supplemental Redundancy
    • UPC/EAN/JAN Supplemental AIM ID Format
    • Transmit UPC-A Check Digit
    • Transmit UPC-E Check Digit
    • Transmit UPC-E1 Check Digit
    • UPC-A Preamble
    • UPC-E Preamble
    • UPC-E1 Preamble
    • Convert UPC-E to UPC-A
    • Convert UPC-E1 to UPC-A
    • EAN-8/JAN-8 Extend
    • Bookland ISBN Format
    • UCC Coupon Extended Code
    • Coupon Report
    • ISSN EAN
  • Code 128
    • Enable/Disable Code 128
    • Set Lengths for Code 128
    • Enable/Disable GS1-128 (formerly UCC/EAN-128)
    • Enable/Disable ISBT 128
    • ISBT Concatenation
    • Check ISBT Table
    • ISBT Concatenation Redundancy
  • Code 39
    • Enable/Disable Code 39
    • Enable/Disable Trioptic Code 39
    • Convert Code 39 to Code 32
    • Code 32 Prefix
    • Set Lengths for Code 39
    • Code 39 Check Digit Verification
    • Transmit Code 39 Check Digit
    • Code 39 Full ASCII Conversion
    • Code 39 Buffering (Scan & Store)
  • Code 93
    • Enable/Disable Code 93
    • Set Lengths for Code 93
  • Code 11
    • Code 11
    • Set Lengths for Code 11
    • Code 11 Check Digit Verification
    • Transmit Code 11 Check Digits
  • Interleaved 2 of 5 (ITF)
    • Enable/Disable Interleaved 2 of 5
    • Set Lengths for Interleaved 2 of 5
    • I 2 of 5 Check Digit Verification
    • Transmit I 2 of 5 Check Digit
    • Convert I 2 of 5 to EAN-13
  • Discrete 2 of 5 (DTF)
    • Enable/Disable Discrete 2 of 5
    • Set Lengths for Discrete 2 of 5
  • Codabar (NW - 7)
    • Enable/Disable Codabar
    • Set Lengths for Codabar
    • CLSI Editing
    • NOTIS Editing
  • MSI
    • Enable/Disable MSI
    • Set Lengths for MSI
    • MSI Check Digits
    • Transmit MSI Check Digit(s)
    • MSI Check Digit Algorithm
  • Chinese 2 of 5
    • Enable/Disable Chinese 2 of 5
  • Matrix 2 of 5
    • Enable/Disable Matrix 2 of 5
    • Set Lengths for Matrix 2 of 5
    • Matrix 2 of 5 Check Digit
    • Transmit Matrix 2 of 5 Check Digit
  • Korean 3 of 5
    • Enable/Disable Korean 3 of 5
  • Inverse 1D
  • Postal Codes
    • US Postnet
    • US Planet
    • Transmit US Postal Check Digit
    • UK Postal
    • Transmit UK Postal Check Digit
    • Japan Postal
    • Australia Post
    • Australia Post Format
    • Netherlands KIX Code
    • USPS 4CB/One Code/Intelligent Mail
    • UPU FICS Postal
  • GS1 DataBar (formerly RSS, Reduced Space Symbology)
    • GS1 DataBar
    • GS1 DataBar Limited
    • GS1 DataBar Expanded
    • Convert GS1 DataBar to UPC/EAN
  • Composite
    • Composite CC-C
    • Composite CC-A/B
    • Composite TLC-39
    • UPC Composite Mode
    • Composite Beep Mode
    • GS1-128 Emulation Mode for UCC/EAN Composite Codes
  • 2D Symbologies
    • Enable/Disable PDF417
    • Enable/Disable MicroPDF417
    • Code 128 Emulation
    • Data Matrix
    • Data Matrix Inverse
    • Decode Mirror Images (Data Matrix Only)
    • Maxicode
    • QR Code
    • QR Inverse
    • MicroQR
    • Aztec
    • Aztec Inverse
  • Redundancy Level
  • Security Level
    • Intercharacter Gap Size
  • Macro PDF Features
    • Macro PDF User Indications
    • Macro PDF Transmit / Decode Mode Symbols
    • Transmit Macro PDF Control Header
    • Escape Characters
    • Flush Macro Buffer
    • Abort Macro PDF Entry
• Miscellaneous Options
  • Introduction
  • Scanning Sequence Examples
  • Errors While Scanning
  • Miscellaneous Parameter Defaults
  • Miscellaneous Parameters
    • Transmit Code ID Character
    • Prefix/Suffix Values
    • Scan Data Transmission Format
    • FN1 Substitution Values
    • Transmit “No Read” Message
    • Report Version
• Driver’s License Set Up (DS457-DL)
  • Introduction
  • Driver’s License Parsing
  • Parsing Driver’s License Data Fields (Embedded Driver's License Parsing)
    • Embedded Driver's License Parsing Criteria - Code Type
    • Driver’s License Parse Field Bar Codes
    • AAMVA Parse Field Bar Codes
  • Parsing Rule Example
    • Embedded Driver's License Parsing ADF Example
  • Field Update Procedure
  • User Preferences
    • Set Default Parameter
    • Send Keystroke (Control Characters and Keyboard Characters)
• 123Scan2
  • Introduction
  • Communication with 123Scan2
  • 123Scan2 Requirements
• Advanced Data Formatting
  • Introduction
• Standard Default Parameters
  • Default Parameters
  • Reserved Parameters
• Programming Reference
  • Code Identifiers
    • AIM Code Identifiers
• Sample Bar Codes
  • Code 39
  • UPC/EAN
    • UPC-A, 100 %
    • EAN-13, 100 %
  • Code 128
  • Interleaved 2 of 5
  • GS1 DataBar-14
  • PDF417
  • Data Matrix
  • Maxicode
• Numeric Bar Codes
  • Numeric Bar Codes
  • Cancel
• ASCII Character Set
• Index